Online Manual: "User Management Resource Adminstrator"
Go to: User Management Resource Administrator homepage
LDAP Directory Service - LDAP Search
The LDAP Search window is used
to specify the LDAP search.
Session
The variable representing the LDAP Session that is initialized with action
Setup LDAP session.
- Result
- The name of the variable that is used to store the
result of the search. The search result is always stored as a table. The
variable does not need to exist when the action is executed. If it does
exist, the old value is overwritten.
Base (DN)
The distinguished name of the directory service tree where the search should
start. The search is executed at the specified base, and optionally in
the immediate or all subtrees of the directory service.
Filter
The specification of the filter to perform the search. The standard search
specification according to RFC2254 can be used to execute the search.
Scope
|
Base only |
Limits the search to the specified base only.
The maximum number of matching directory service items is 1. |
|
One level |
The search is performed in all entries of
the first level below the base entry, excluding the base entry. |
|
Subtree |
The search is performed in the base entry
and all levels below the base entry. |
Options
|
Time out interval |
When enabled, the specified value is the time-out
value of the LDAP search and the operation time. If disabled, no time-out
value is used. |
|
Size limit |
When enabled, the maximum number of matching
values is limited to the specified value. When disabled, the maximum number
of items is not limited. |
See also:
Managing LDAP
Directory Services using UMRA - Introduction
Managing LDAP
Directory Services using UMRA - Concept
LDAP Directory
Service - LDAP Search Attributes
| 
